|
|
Standard Specifications
Driving Belt - 4" wide Black PVC 120 belt.
Bed - Roller bed width between frames, 10", 13", 16" and
22". 5 1/2" x 1 1/2" x 12 gauge painted formed steel channel frame, bolted
together with butt couplings and floor supports.
Tread Rollers - 1 3/8" diameter x 18 gauge galvanized tread rollers
with 5/16" hex shafts on 1 1/2" and 3" centers. Safety pop-out design
prevents damage to product or harm to personnel if caught between belt and tread rollers.
Pressure Rollers - 1 3/8" diameter x 18 gauge galvanized pressure
rollers with 5/16" hex shafts on 6" centers.
X-Bracing - Frame squaring device supplied on conveyors 40 feet and
longer on every other bed section. X-Bracing insures good product and belt tracking.
Tail Pulley - 4" diameter crowned with 1 3/16" shaft.
Drive Pulley - 4" diameter crowned and fully lagged with 1
3/16" shaft.
Snub Roller - 2" diameter adjustable, located directly behind drive
and tail pulley.
Return Rollers - 1.9" diameter, adjustable, on 10'0" centers.
Floor Supports - 30" to 44" adjustable from floor to top of
rollers. One support supplied at each end of conveyor and at each bed joint.
Take-Up - Located at discharge end of conveyor, provides 12" of belt
take-up.
Bearings - Sealed, prelubricated with cast iron housings.
Speed Reducer - Heavy duty worm gear reducer.
Motor - 1/2 HP 230-460-3-60 TE motor.
Belt Speed - 60 FPM constant.
Capacity - 100 pound per foot. See Load Capacity Chart
specifications chart | optional equipment | modifications
|
|
