|
|
Standard Specifications
Driving Belt -
Black 120 PVC belt.
Bed - Roller bed with between frames, 15", 21", 27",
33" and 39", 7" x 1 1/2" x 12 gauge formed painted steel channel
frame, bolted together with butt couplings and floor supports. Frame sections are
10'0" and 5'0" long.
Tread Rollers - 1.9" diameter x 16 gauge galvanized steel rollers
spaced on 3" or 6" centers. Safety pop-out design prevents damage to product or
harm to personnel if caught between belt and tread rollers.
Pressure Rollers - 1/9" diameter x 16 gauge galvanized steel rollers
with 7/16" Hex shaft spaced on 6" and 12" centers. Raised by air to drive
tread rollers, lowered when sensing device is activated.
Sensing Device - NEMA 1 photoelectric sensor in each zone detects
presence of product and activates accumulation feature in the trailing zone if upstream
zone is occupied.
Power Supply - 120 VAC power supply controls accumulation feature with 24
VDC output. Power supply will control 100 accumulation zones.
Air Requirements - Minimum 30 psi on main trunk line.
Accumulation Zones - 24", 30" or 36" long, air operated.
Conveyor frame lengths change with zone lengths. (NOTE: Zone length must be evenly divisible by roller centers.)
Filter/Regulator -
Supplied loose for mounting to conveyor side frame, with 3/8" NPT ports. 35 to 40 psi
recommended operating pressure with free air consumption of .0062 cu.ft. per sensor
operation.
Guard Rails - Built in guard rails. Note: Product contact with guard
rails will affect product flow.
Tail Pulley - 4" diameter crowned with 1 3/16" diameter shaft.
Drive Pulley - 8" diameter crowned and fully lagged with 1
7/16" diameter shaft. Located at infeed end of conveyor.
Snub Roller - 2 1/2" diameter adjustable mounted directly behind
drive pulley, 2" diameter adjustable mounted directly behind tail pulley.
Return Idler - 1.9" diameter, adjustable, on 10'0" centers.
Floor Supports - Adjustable 31 12" to 45 1/2" from floor top
top of roller . One support supplied at each end of conveyor and at each bed joint.
Take-Up - Screw type take-up placed at end of conveyor to maintain belt
tension. 12" of belt take-up provided.
Bearings - Sealed, prelubricated with cast iron housings.
Speed Reducer - C-Face mounted heavy duty worm gear reducer.
Motor - 1/2 HP 230/460/3/60 TE Motor.
Conveyor Speed - 60 FPM constant. Some higher and lower speeds are
available. However, most efficient accumulation occurs at 60 FPM.
Capacity - Maximum load 150 lbs. maximum unit load. Not to exceed Load
Capacity Chart.
specifications chart - acrobat
chart | optional equipment - acrobat file
modifications
|
|
