|
|
Standard Specifications
Belt - 12", 16", 18", 20", 24' and 30" wide
ruff-top belt.
Bed - Roller bed with 1.9" diameter x 16 gauge galvanized rollers
spaced on 6" centers. Rollers mounted in 7" x 1 1/2" x 12 gauge painted
formed steel channel frames. Frames bolted together with butt couplings.
Under-Trussed Bed - Extra reinforcement to prevent sag in longer bed
sections in addition to reinforcing angles, 20 feet and longer.
X-Bracing - Supplied on conveyors 40 feet and longer. Used to square bed
sections to insure proper product and belt tracking.
Double Nose-Over - Adjustable from 0° to 35°.
Center Drive - Mounted below conveyor bed section. Can be placed most
anywhere in conveyor length.
Tail Pulley - 4" diameter crowned with 1 3/16" diameter shaft
for up to 30" wide belt. 4" diameter crowned with 1 7/16" diameter shaft
turned down to 1 3/16" diameter on each end for 36" belt.
Drive Pulley - 8" diameter and fully lagged, 1 7/16" diameter
shaft.
Snub Roller - 2 1/2" diameter at drive pulley, 2" diameter at
terminal pulleys.
Return Roller - 1.9" diameter.
Take-Up - Located in center drive, provides 24" of belt take-up.
Gravity Brackets - Adjustable rod with 1 3/8" diameter pop-out
transfer roller to attach wheel or 1 3/8" diameter roller conveyor.
Bearings - Sealed prelubricated with cast iron housings.
Floor Supports - Adjustable 31 1/2" to 45 1/2" from floor to
top of belt. One support supplied at each end of conveyor and at nose-over, with knee
braces.
Speed Reducer - C-Face mounted heavy duty worm gear reducer.
Motor - 3/4 HP 230/460-3-60 TE Motor.
Belt Speed - 60 FPM Constant.
Capacity - See Load Capacity Chart
specifications chart | optional equipment
modifications |
|
