|
|
Standard Specifications
Driving Belt - Black PVC 120 belt.
Bed - Roller bed width between frames, 15", 21", 27",
33" and 39", 7" x 1 1/2" x 12 gauge formed painted steel channel
frame, bolted together with butt couplings and floor supports. Frame sections are
10'0" and 5'0" long.
Tread Rollers - 1.9" diameter x 16 gauge galvanized steel rollers
spaced on 3" or 6" centers. Safety pop-out design prevents damage to product or
harm to personnel if caught between belt and tread rollers.
Pressure Rollers - 1.9" diameter x 16 gauge galvanized steel rollers
with 7/16" hex shaft spaced on 6" and 12" centers. Raised by air and drive
tread rollers, lowered when sensing device is activated.
Tail Pulley - 4" diameter crowned with 1 3/16" diameter shaft.
Drive Pulley - 8" diameter crowned and fully lagged with 1 /16"
diameter shaft. Located at infeed end of conveyor.
Snub Roller - 2 1/2" diameter adjustable mounted directly behind
drive pulley, 2" diameter adjustable mounted directly behind tail pulley.
Return Roller - 1.9" diameter, adjustable, on 10'0" centers.
Floor Supports - Adjustable 31 1/2" to 45 1/2" from floor to
top of roller. One support supplied at each end of conveyor and at each bed joint.
Sensing Roller - 1" diameter galvanized, mounted in counter balanced
carriage, one for each zone. Standard zones are 18", 24", 30" and 36"
long.
Take-Up - Screw type take-up located at end of conveyor to maintain belt
tension. 12" of belt take-up provided.
Bearings - Sealed, prelubricated with cast iron housings.
Speed Reducer - C-Face mounted heavy duty worm gear reducer.
Motor - 1/2 HP 230/460-3-60 TE motor.
Conveyor Speed - 60 FPM constant. Some higher and lower speeds available.
However, most efficient accumulation occurs at 60 FPM.
Capacity - 150 pounds maximum unit load.
specifications chart - acrobat chart
| optional equipment - acrobat files
modifications |
|
