|
|
Standard Specifications
Frame - Heavy Duty 12 1/2" deep x 7 gauge formed
and painted steel channel with heavy duty cross braces. Frames are bolted together
with splice plates and floor supports.
Rollers - 2 1/2" diameter x 11 gauge steel rollers, grease packed
and labyrinth sealed bearings, 11/16" hex shaft. Rollers are spaced on 4" or
6" centers, set 7/8" low.
Floor Supports - Adjustable 25 5/8" to 30 1/4" (HD-4) from
floor to top of roller, for each end of conveyor and at each bed joint along with knee
braces for each support. Supports on 5 foot centers, change with zone length. Minimum
elevation with standard drive location 24"
Drive - Located near center of conveyor length, underneath conveyor
frame.
Drive Chain - RC 40 chain used for roller-to-roller connections, RC-60
chain drives each zone. Chains are totally enclosed by metal guards.
Accumulation Zones - Standard zones are 60" long with maximum of 30
zones per single drive.
Motor - 3/4 HP 230-/460-3-60 TE motor.
Electrical Controls - 110/1/60 AC solenoid and limit switch for discharge
zone.
Conveyor Speed - 30 FPM constant roller speed.
Capacity - 4000 lbs. maximum unit load. Total conveyor live load not to
exceed Load Capacity Chart.
Speed Reducer - Heavy duty, sealed worm gear, C-Face.
Bearings - Sealed, prelubricated with cast iron housings.
specifications chart -
acrobat chart | optional equipment -
acrobat file
modifications |
|
