MODEL “138CLR”

Driving Belt – “B” section V-belt.
Bed – Roller bed width between frames, 10″, 13″, 16″ and 22″.  5-1/2″ x 1-1/2″ x 12 gauge powder painted formed steel channel frame.
Tread Rollers – 1-3/8″ diameter x 18 gauge galvanized steel tread rollers, 1-1/2″ centers, 5/16″ hex shaft for 13″-19″ OAW.  2-1/2″ to 1-11/16″ tapered roller for 25″ OAW conveyor, 7/16″ hex shaft.
Pressure Sheaves – 3″ diameter x 3/8″ bore, adjustable to give required driving force.
Floor Supports – Adjustable 30″ to 44″ from floor to top of rollers.  One support at each end, center leg on outer rail.
Tangent – 12″ long, one on each end.
Take-Up – Screw take-up provided to insure proper V-belt tension.  Mounted underneath conveyor.
End Drive – Mounted below bed section.
Bearings – Sealed prelubricated with cast iron housings.
Speed Reducer – C-Face mounted heavy duty worm gear reducer.
Motor – 1/2 HP 230/460-3-60 TE motor.
Conveying Speed – 60 FPM constant.
Capacity – 300 Ibs. total distributed live load.
(For Optional Equipment, Weight Specifications, and Engineering Line Drawings, please see catalog pages, above).

ACSI Paint Colors

(Optional colors available at extra cost)

 Guard Rails – Adjustable channel, continuous channel,steel guard rails available.

Floor Supports – Lower or higher supports are available. Minimum elevation 15-1⁄2″.

Ceiling Hangers – 1 ⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Side Mounted Drive – End drive mounted to side of conveyor bed section. Minimum elevation 8″. Specify side. Minimum tangent length – 18″.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Conveying Speed – Variable and other constant speeds available.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others.