|
|
Standard Specifications
Belt - 14", 18", 24", 30" and 36" wide ruff-top
belt.
Bed - 20", 24", 30", 36" and 42" wide 12 gauge
painted formed steel slider bed. Bed is 6 1/2" deep x 6 feet, 8 feet, or 10 feet long
spliced together with splice plates.
Under-Trussed Bed - Extra reinforcement to prevent sag in longer bed
sections in addition to reinforcing angles, 24 feet and longer.
Double Nose-Over - Two 16" long adjustable bed sections provide a
two step transition from inline to horizontal with 15° to 35° adjustment.
Tail Pulley - 4" diameter, crowned with 1 3/16" diameter shaft
through 30" wide belt. 6" diameter tail pulley with 1 7/16" diameter shaft
turned down on ends for wider than 30" belt.
Drive Pulley - 8" diameter crowned and lagged. 1 7/16" diameter
shaft.
Snub Roller - 2 1/2" diameter at drive pulley and 2" diameter
at tail pulley.
Return Idlers - 1.9" diameter, adjustable.
Take-Up - Located in center drive assembly, provides 24" belt
take-up.
Pop-Out Roller - Free floating, 1 3/8" diameter rollers located at
tail pulleys with gravity connector rods. Will lift out if anything is caught between
pulleys and rollers.
Floor Supports - Adjustable stands to give 31" to 45" height at
each end; with knee braces.
Bearings - Sealed prefabricated with cast iron housings.
Speed Reducer - C-Face mounted heavy worm gear reducer.
Motor - 3/4 HP 230/460-3-60 TE Motor.
Belt Speed - 60 FPM Constant.
Capacity - 100 lbs. per foot maximum live load. Not to
exceed Load Capacity Chart
specifications chart | optional equipment
modifications
|
|
