STANDARD SPECIFICATIONS
MODEL "251CDA"
Heavy Duty Mechanically Controlled Chain Driven Pallet Accumulating Conveyor
Heavy Duty Mechanically Controlled Chain Driven Pallet Accumulating Conveyor
• Zero pressure accumulation
• Mechanically operated
• Heavy duty construction
• Chain driven rollers
• Zone connections outside
frame for easy installation
• Mechanically operated
• Heavy duty construction
• Chain driven rollers
• Zone connections outside
frame for easy installation
Applications / Features:
Frame - Heavy duty 12-1/2" deep x 7 gauge powder painted formed steel channel with heavy duty cross braces. Frames are bolted with spice plates and floor supports.
Rollers - 2-1/2" diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 11/16" hex shaft. Rollers are spaced on 4" or 6" centers, set 7/8" low.
Floor Supports - Adjustable 25-5/8" to 30-1/4" (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support. Supports on 5 foot centers, change with zone length. Minimum elevation with standard drive location 24".
Drive - Located near center of conveyor length, underneath conveyor frame.
Drive Chain - RC #40 for roller to roller connections, RC #60 chain drives each zone. Chains are totally enclosed by metal guards.
Accumulation Zones - Standard zone lengths are 60" long with a maximum of 30 zones per single drive
Motor - 3/4 HP 230/460-3-60 TE motor.
Electrical Controls - Input to a power supply.
Conveyor Speed - 30 FPM constant roller speed.
Speed Reducer - Heavy duty, sealed worm gear, C-Face.
Bearings - Non-reversing sealed pre-lubricated with cast iron housing
Capacity - Minimum unit load - 50 pounds. 4000 pounds maximum unit load. Total conveyor live load not to to exceed Load Capacity Chart (see catalog page). For loads less than 50lbs. you must consult the factory.
(For Optional Equipment, Weight Specifications, and Engineering Line Drawings, please see catalog pages, above).
Rollers - 2-1/2" diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 11/16" hex shaft. Rollers are spaced on 4" or 6" centers, set 7/8" low.
Floor Supports - Adjustable 25-5/8" to 30-1/4" (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support. Supports on 5 foot centers, change with zone length. Minimum elevation with standard drive location 24".
Drive - Located near center of conveyor length, underneath conveyor frame.
Drive Chain - RC #40 for roller to roller connections, RC #60 chain drives each zone. Chains are totally enclosed by metal guards.
Accumulation Zones - Standard zone lengths are 60" long with a maximum of 30 zones per single drive
Motor - 3/4 HP 230/460-3-60 TE motor.
Electrical Controls - Input to a power supply.
Conveyor Speed - 30 FPM constant roller speed.
Speed Reducer - Heavy duty, sealed worm gear, C-Face.
Bearings - Non-reversing sealed pre-lubricated with cast iron housing
Capacity - Minimum unit load - 50 pounds. 4000 pounds maximum unit load. Total conveyor live load not to to exceed Load Capacity Chart (see catalog page). For loads less than 50lbs. you must consult the factory.
(For Optional Equipment, Weight Specifications, and Engineering Line Drawings, please see catalog pages, above).
Horizontal Powered
STANDARD SPECIFICATIONS
Engineering Data
Inclined Powered
