STANDARD SPECIFICATIONS
• Handles pallets the hard way
• Quiet operation
• Low profile - 12" elevation
optional
• Photo eye controlled
• Quiet operation
• Low profile - 12" elevation
optional
• Photo eye controlled
Applications / Features:
MODEL "DCE"
Drag Chain Photo Eye Controlled
Accumulating Conveyor
Drag Chain Photo Eye Controlled
Accumulating Conveyor
Installation Manual
Horizontal Powered
STANDARD SPECIFICATIONS
Engineering Data
Inclined Powered
Frame - 9" x 7 gauge powder painted formed steel channel frames. Sections are bolted together with splice plates and floor supports.
Chain - (2) 60F single pitch conveyor chains, straight side bar, on 36" centers.
Chain Guide - UHMW.
Floor Supports - 24" to top of chain. One support supplied at each end of conveyor and at each bed joint.
Motor - 1 HP 230/460-3-60 TE motor, C-Face. Motor and speed reducer are located underneath conveyor frame.
Speed Reducer - Heavy duty worm gear for C-Face mounted motor.
Sprockets - Hardened sprokets with 1-15/16" diameter CRS drive shaft.
Bearings - Sealed, pre-lubricated with cast iron housing.
Accumulation Zones - Standard zones are 60" long with a maximum of 20 zones per single drive. Each zone is driven by an air clutch and controlled by a photo eye.
Power Supply - 120VAC power supply controls accumulation feature with 24VDC output. Power supply will control 50 accumulation zones.
Sensing Device - NEMA 1 photo electric sensor in each zone. Detects product presence and activates accumulation feature if downstream zone is occupied.
Speed - 30 FPM constant speed.
Capacity - 10,000 lbs. maximum distributed live load at 30 FPM. Maximum motor size is 3 HP. Not to exceed Load Capacity Chart (see catalog page).
(For Optional Equipment, Weight Specifications, and Engineering Line Drawings, please see catalog pages, above).
Chain - (2) 60F single pitch conveyor chains, straight side bar, on 36" centers.
Chain Guide - UHMW.
Floor Supports - 24" to top of chain. One support supplied at each end of conveyor and at each bed joint.
Motor - 1 HP 230/460-3-60 TE motor, C-Face. Motor and speed reducer are located underneath conveyor frame.
Speed Reducer - Heavy duty worm gear for C-Face mounted motor.
Sprockets - Hardened sprokets with 1-15/16" diameter CRS drive shaft.
Bearings - Sealed, pre-lubricated with cast iron housing.
Accumulation Zones - Standard zones are 60" long with a maximum of 20 zones per single drive. Each zone is driven by an air clutch and controlled by a photo eye.
Power Supply - 120VAC power supply controls accumulation feature with 24VDC output. Power supply will control 50 accumulation zones.
Sensing Device - NEMA 1 photo electric sensor in each zone. Detects product presence and activates accumulation feature if downstream zone is occupied.
Speed - 30 FPM constant speed.
Capacity - 10,000 lbs. maximum distributed live load at 30 FPM. Maximum motor size is 3 HP. Not to exceed Load Capacity Chart (see catalog page).
(For Optional Equipment, Weight Specifications, and Engineering Line Drawings, please see catalog pages, above).
(Optional colors available at extra cost.)
Optional ACSI Colors