Model “251ACDA” Heavy Duty Chain Driven Air Operated Pallet Accumulating Conveyor

Frame — Heavy duty 7" deep x 4 gauge powder painted formed steel channel with heavy duty cross braces. Frames are bolted together with splice plates and floor supports.

Rollers — 2-1/2" diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 1-1/16" hex shaft. Rollers are spaced on 4" or 6" centers, set 2-1/4" low.

Floor Supports — Adjustable 18-3/4" to 23-3/8" (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support. Supports on 5 foot centers, changes with zone length.

Drive — Located near center of conveyor length, shaft mount motor and reducer.

Drive Chain — RC 40 chain used for roller-to-roller connections, RC 60 chain drive each zone. Chains are totally enclosed by metal guards.

Accumulation Zones — Standard zones are 60" long with a maximum of 30 zones per single drive. Each zone is driven by an air clutch and controlled by a sensor roller.

Motor — ¾ HP 230/460-3-60 TE motor.

Electrical Controls — 110/1/60 Electric Solenoid and Air switch for discharge zone.

Conveyor Speed — 30 FPM constant roller speed.

Capacity — Minimum unit load - 50 lbs. 4,000 lbs. Maximum unit load. Total conveyor live load not to exceed Load Capacity Chart. For loads less than 50 lbs., consult factory.

Speed Reducer — Heavy duty, sealed worm gear, C-Face.

Bearings — Sealed prelubricated with cast iron housings.

Accumulation Zones — 4" roller centers - 36", 40", 44", 48", 52", 56" and 72" long. 6" roller centers 36", 42", 48", 54" and 72" long. Frame lengths change with zone lengths.

Tread Rollers — 2-5/8" diameter x 7 gauge steel, 1-1/16" hex shaft.

Floor Supports — Higher or lower supports available, adjustable or fixed type.

Conveyor Speed — Constant and variable speeds (Contact Factory).

Limit Switch — to provide signal for customers infeed equipment.

Time Delay — Allows for product to be unloaded from discharge zone of conveyor without movement of next load into discharge zone.

Sensing Devices — Photo cells, limit switches, etc. can be supplied for electrically operated zones in lieu of mechanical sensing devices.

Motor — Single phase, energy efficient, explosion proof, etc. Other HP available.

Electrical Controls — Magnetic starters and push button stations; Manual motor starters with overload protection, others. 24V DC solenoid can be supplied in lieu of 110V AC solenoid in discharge zone.

Optional Loads — Larger capacity clutch is available for 6000 lb. unit loads.

Reversible — can be supplied with reversing feature to allow accumulation in both directions.