Model “190CLR” Medium Duty V-Belt Roller Curve

Driving Belt — “B” section V-belt.

Bed — Roller bed width between frames: 15″, 21″, 27″, 33″, and 39″. 2-1/2″ diameter tapered to 1-11/16″ diameter x 14 gauge wall plated tread rollers with ⁷/₁₆″ hex shafts. Steel pressure sheaves mounted in 7″ x 1-1/2″ x 12 gauge powder painted formed steel channel frame.

Floor Supports — Adjustable 31-1/2″ to 45-1/2″ from floor to top of rollers. One support at each end, and center leg on outer rail.

Take-Up — Screw take-up provided to ensure proper V-belt tension. Mounted underneath conveyor.

Tangent — 12″ long, one on each end.

End Drive — Mounted below bed section.

Bearings — Sealed prelubricated with cast iron housings.

Speed Reducer — C-Face mounted heavy duty worm gear reducer.

Motor — ¹/₂ HP 230/460-3-60 TE motor.

Belt Speed — 60 FPM constant.

Capacity — 540 lbs. total distributed live load.

Guard Rails — Adjustable channel, continuous channel, or steel guard rails are available.

Floor Supports — Lower or higher supports are available. Minimum elevation 17″ from floor to top of rollers.

Ceiling Hangers — ¹/₂″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Side Mounted Drive — End drive mounted to side of conveyor bed section. Minimum elevation 9-1/2″. Specify side.

Motor — Single phase, energy efficient, explosion proof, etc. Other HP available.

Belt Speed — Constant and variable belt speeds available.

Electrical Controls — Magnetic starters and push button stations; manual motor starters with overload protection, others.

Tangents — Standard tangents are 12″ long, located at each end of curve. Longer tangents are available. Contact factory.