Model “190LSE” Line Shaft Live Roller Photo Eye Controlled Accumulating Conveyor

Driving Belts — 3⁄16" diameter round urethane “O” rings from drive shaft to tread rollers.

Bed — 7" x 1-1/2" x 12 gauge powder painted formed steel channel frame with heavy duty cross braces and splice plates.

Rollers — 1.9" diameter x 16 gauge galvanized steel tread rollers with 7/16" hex shaft and sealed, greased-for-life bearings, spaced on 3" centers.

Sensing Device — NEMA 1 photoelectric sensor in each zone detects presence of product and activates accumulation feature in the trailing zone if the upstream zone is occupied.

Power Supply — 120 VAC power supply controls accumulation feature with 24 VDC output. Power supply will control 50 accumulation zones.

Air Requirements — 20 to 35 psi recommended operating pressure with free air consumption of .0062 cu. ft. per sensor operation.

Accumulation Zones — 24", 30", or 36" long, air operated. Conveyor frame length changes with zone lengths. Note: zone length must be evenly divisible by roller centers.

Filter/Regulator — Supplied loose for mounting to conveyor side frame, with 3⁄8" NPT ports.

Guard Rails — 1-1/2" x 1-1/2" x 12 gauge galvanized guard rails, both sides. NOTE: Product contact with guard rails will affect product flow.

Floor Supports — Adjustable 31-1/2" to 45-1/2" from floor to top of tread roller. One support supplied at each end of conveyor and at each bed joint.

Drive — 2 foot module with motor and reducer. Drive module will be bolted to intermediate section.

Drive Shaft — 1" diameter steel shaft, driven by motor and reducer, runs full length of conveyor. Chain coupling supplied at bed joints to couple sections together.

Drive Spools — Delrin spools located on drive shaft supply driving power to tread rollers.

Drive Shaft Bearings — Sealed, prelubricated, self-aligning, precision ball bearings on drive shaft.

Speed Reducer — C-Face mounted heavy duty worm gear reducer.

Motor — ½ HP 230/460/3-60 TE motor.

Drive Guard — Expanded metal guard full length of conveyor covers drive shaft and other moving drive components.

Conveying Speed — 60 FPM constant.

Capacity — 15 lbs. per tread roller maximum. Not to exceed Load Capacity Chart.

Conveying Speed — Constant and variable speeds from 30 to 120 FPM available.

Timing Belt Drive — For speeds 90 FPM and above a timing belt drive in lieu of #50 chain drive is recommended.

Roller Centers — 2-1/4", 4", 6", or 8" centers. NOTE: Capacities change as roller centers change. See engineering section of price list for capacity changes.

Accumulation Zones — 18" long, air operated. Conveyor frame lengths change with zone lengths. NOTE: Zone length must be evenly divisible by roller centers.

Floor Supports — Lower or higher supports available. Minimum elevation with standard drive mounting is 18" from floor to top of rollers.

Powered Right Angle Belt Transfer — Air operated pop-up round belt transfer mounted in a 32" long modular section, 75 lbs. maximum unit load. Reversing UBT is 39" long.

Package Stops — Manual or air operated blade or roller stops available.

Slug Release — Allows for conveyor to be quickly unloaded when accumulation feature is not required.

Motor — Single phase, energy efficient, explosion proof, etc. Other HP available.

Ceiling Hangers — ½" diameter threaded rods 8 feet long with locking nuts and mounting hardware.

Jump Chain — One-to-one chain drive moves drive shaft to opposite side for driving various optional accessories.