Model “251CDA” Heavy Duty Chain Driven Pallet Accumulating Live Roller Conveyor

Frame — Heavy duty 12-1/2" deep x 7 gauge powder painted formed steel channel with heavy duty cross braces. Frames are bolted together with splice plates and floor supports.

Rollers — 2-1/2" diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 1-1/16" hex shaft. Rollers are spaced on 4" or 6" centers, set 7⁄8" low.

Floor Supports — Adjustable 25-5/8" to 30-1/4" (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support. Supports on 5 foot centers, change with zone length. Minimum elevation with standard drive location 24".

Drive — Located near center of conveyor length, underneath conveyor frame.

Drive Chain — RC 40 chain used for roller-to-roller connections, RC 60 chain drives each zone. Chains are totally enclosed by metal guards.

Accumulation Zones — Standard zones are 60" long with maximum of 30 zones per single drive.

Motor — ¾ HP 230/460-3-60 TE motor.

Conveyor Speed — 30 FPM constant roller speed.

Capacity — Minimum unit load - 50 pounds. 4000 pounds maximum unit load. Total conveyor live load not to exceed Load Capacity Chart. For loads less than 50 lbs., consult factory.

Speed Reducer — Heavy duty, sealed worm gear, C-Face.

Bearings — Sealed prelubricated with cast iron housings.

Accumulation Zones — 4" roller centers 36", 40", 44", 48", 52", 56" and 72" long. 6" roller centers 36", 42", 48", 54" and 72" long. Frame lengths change with zone lengths.

Tread Rollers — 2-5/8" diameter x 7 gauge steel, 1⁄16" hex shaft.

Floor Supports — Higher or lower supports available, adjustable or fixed type.

Side Mounted Drive — Drive unit mounted to side of conveyor in lieu of underneath conveyor frame. 14" minimum elevation to the top of roller.

Conveyor Speed — Constant and variable speeds between 10 and 70 FPM available.

Limit Switch — To provide signal for customers infeed equipment.

Time Delay — Allows for product to be unloaded from discharge zone of conveyor without immediate movement of next load into discharge zone.

Motor — Single phase, energy efficient, explosion proof, etc. Other HP available.

Electrical Controls — Magnetic starters and push button stations; manual motor starters with overload protection, others.

Rollers Set High — Rollers set ¼" high above side rail. Frame is 11-3/8" deep x 7 gauge formed steel channel.